My Cart

Stanley Hydraulic Submersible Pump

4" Hydraulic submersible pump
Model Number
TP08
$4,537.12
Stanley Hydraulic Submersible Pump

Trash Pumps Hydraulic submersible TP08-013. Like our detwatering pumps, the pure power of hydraulic tools is also exemplified in our trash pumps. Stanley TP08013 pump discharges an impressive 800 gallons per minute (3028 lpm) and can handle up to 3 inch (102 mm) diameter solids, slurries, gravel and sludge. 

Pump can handle the removal of water containing solids up to 30%. It is perfect in the pumping sites of water, sand slurries, gravel and sludge on job sites.

Click here for alternate gas engine submersible.

Stanley trash pump features are:

  • 7-10 gpm (26-38 lpm) hydraulic oil operating range, 2000psi (140bar).
  • Urethane (TP03) and cast iron (TP08) impeller.
  • Submersible (no priming required) 
  • Able to pump up to 30% solids easily. 
  • Urethane (TP03) and steel (TP08) bowl. 
  • Lifting eye and carrying handle. 
  • HTMA quick disconnect couplers. 
  • 3 inch (TP03) and 4 inch (TP08) discharge. 
  • High flow, low pressure dewatering and liquid transfer.

It quickly and efficiently empty sumps, vaults,septic systems, trenches, etc. High suction lift applications such as sewer bypass jobs. Dewatering of mines, quarries and gravel pits. Benefit: No suction line limitations. Unattended operation. Submerged pump head. Variable speed. No electrical requirements. One person operation at only 59LBS.

With a new custom bottom plate that includes a hose connection, these pumps can be made to "slurp" or suck liquid from a deeper location. They can "draw down" with a suction tail pipe. Used in underwater excavating. Consult your PumpBiz Application Engineer.

Hydraulic motor must return into a open / non-pressurized reservoir open circuit. Back pressure on the discharge / return side of the hydraulic will damage shaft seal. Skid steer need to be aware of this.

More Information
Model Number TP08
Series Stanley Hydraulic Trash pumps
Max Flow (GPM.) 800
Max Flow GPH 48000
TDH Maximum (Ft) 45
TDH Maximum (PSI) 19
Watts 0.000000
Outlet Connection Type MNPT
Outlet (In.) 4
Wetted Materials Aluminum, Cast Iron
Motor Hydraulic Motor
Speed (RPM.) variable
Self Priming Yes
Max Operating Temperature (F) 140
Max Particle Size (In) 4
Viscosity Vegetable Oil 34.60 cp 200.00 ssu
Length (In.) 19.000000
Mechanical Seal No
Mechanical Seal Type Double
Other Cast iron impeller and steel bowl. Able to run dry without damage. Hyd. System relief valve should be set at 2250psi. Porting: #10 SAE (Press.) #12 SAE (Ret). Connect Size and Type 1/2 in. Male Pipe (Press.) 3/4 in. Male Pipe (Ret).
Drain No
Port Rotation Yes
Weight (Lbs) 68.000000
Warranty (YRS.) 1

Supporting Docs

Supporting Docs
pdf
(Size: 1.91 MB) Extension: pdf