Stanley Hydraulic Submersible Pump

Dewatering Pumps SM50 pump discharges an impressive 500 gallons per minute (1890 lpm) while it's small size allows it to fit in a box 11 inches deep by 10 inches square (26.7 cm x 25.4 cm). Stanley hydraulic pumps exemplify the pure power of hydraulic tools. 

Stanley dewatering pump features are: • 4-9 gpm hydraulic oil operating range, 2000psi. • Stainless steel, steel, urethane, or cast iron impellers . • Submersible (no priming required) • Able to run dry without damage. • Lifting eye. • 3 inch (SM50100) and 2.5 inch (SM20) discharge. • Wingnuts for easy bowl removal and cleaning.

The urethane bowl is virtually indestructible- tough, lightweight,abrasion resistant, resilient and impervious to petrochemical solvents.The SM50 can run dry without damaging motor or impeller, reducing the possibility of downtime. (**encoding or data invalid**)

Hydraulic motor must return into a open / non-pressurized reservoir open circuit. Back pressure on the discharge / return side of the hydraulic will damage shaft seal. Skid steer need to be aware of this.