Stanley Hydraulic Submersible Pump

Trash Pumps TP03. Like our detwatering pumps, the pure power of hydraulic tools is also exemplified in our trash pumps. •Lightweight and durable Urethane bowl and impeller. Stanley TP0300301 pump discharges an impressive 450 gallons per minute (1688 lpm) and can handle up to 3 inch (76 mm) diameter solids. 

Pump can handle the removal of water containing solids up to 30%. It is perfect in the pumping sites of water, sand slurries, gravel and sludge on job sites.

Click here for alternate gas engine submersible.

• Stanley trash pump features are:
• 7-9 gpm (26-34 lpm) hydraulic oil operating range, 2000psi
• Urethane (TP03) and cast iron (TP08) impeller.
• Submersible (no priming required)
• Able to run dry without damage.
• Handles liquids with up to 25% solids by volume
• Urethane (TP03) and steel (TP08) bowl.
• Accessories Description 52720 Adapter, 3" male npt x 2" male camlock , 73576 Carrying Handle, 73577 Quick Link Connector • HTMA quick disconnect couplers.
• 3 inch (TP03) and 4 inch (TP08) discharge. Includes male QD camlock
• Wingnuts for easy bowl removal and cleaning.

The urethane bowl is virtually indestructible- tough, lightweight,abrasion resistant, resilient and impervious to petrochemical solvents.The TP03 can pump almost anything without damaging the bowl.The TP03’s efficient design places the urethane impeller above material flow, reducing blockage, jamming. For easy maintenance and inspection,simply remove the wingnuts and top plate, clean out the bowl and replace the cover and nuts. You’re back to work in less than 5 minutes. The TP03 can run dry without damaging motor or impeller, reducing the possibility of downtime.It quickly and efficiently empty sumps, vaults,septic systems, trenches, etc.

With a new custom bottom plate that includes a hose connection, these pumps can be made to "slurp" or suck liquid from a deeper location. They can "draw down" with a suction tail pipe. Used in underwater excavating. Consult your PumpBiz Application Engineer. 

Pressure......................................................................................................................... 1500–2000 psi/105–140 bar
Flow Range.............................................................................................................................. 7–9 GPM/26–34 LPM
Maximum Flow................................................................................................................................... 9 GPM/34 LPM
Porting.....................................................................................................................................................1/2 in. NPTF
Connect Size and Type..................................................................................................................... 1/2 in. Male Pipe
Discharge Diameter................................................................................................................. 3 in./76.2 mm Camlock

Hydraulic motor must return into a open / non-pressurized reservoir open circuit. Back pressure on the discharge / return side of the hydraulic will damage shaft seal. Skid steer need to be aware of this.