My Cart

Standby Pump-In-A-Bag kit 1200GPH

  • Model Number:

    Pump-In-A-Bag kit

  • Product Name:
    Standby Pump-In-A-Bag kit 1200GPH
  • Manufacturer:
Low level Pump & Switch
Model Number
Pump-In-A-Bag kit
Standby Pump-In-A-Bag kit 1200GPH by PumpBiz

Little Giant Pump-In-A-Bag kit

Pump-In-A-Bag kit. 1/6 Submersible sump/utility pump with cast aluminum housing, plastic base, bottom sump-type pick-up with removable plastic screen. Includes DFC1 switch for quick and easy automatic LOW level floor flood control or dewatering a flooded basement. Submersible Utility Pump 115V, Manual or automatic, 10' Power Cord. The pump with a 101 uses. Pump-In-A-Bag kit has High flow rate and pressure for such a compact pump in a bag ready to go in a emergency. Connects to 1" pipe or garden hose. Screened inlet, carry handle and epoxy coated aluminum housing. Great for emptying spa, small pool, bathtub, window wells, flat roofs, sink drain and elevator pits. Wash pit sump pump for mobile pressure washing. Use fully or partially submerged. For sucker floor pump with a 25 ft. power cord see 505025 5-MSP.

Unique DFC1 switch, The Dual Float and Controller is for any manual pump. It turns on the pump when water lifts the float switch 1/4", and runs the pump for an additional 10 seconds after the float drops, to completely empty the low area / sump pit once the float returns to its original position. DFC1 has a 10FT cord with piggy back plug. Set the switch housing at any height to get a corresponding On / Off level. For further peace of mind the switch has a Dual float which acts as a backup to the main lower float should it get stuck the second one takes over. Industrial strength electronics, 30 amp relay means extended life compared to ordinary float switch. ON level point is 3/4" from its bottom surface. DFC1 is not rain proof, requires enclosure if exposed to the elements.

Pump-In-A-Bag kits of other sizes

More Information
Model Number Pump-In-A-Bag kit
Max Flow (GPM.) 20
Max Flow GPH 1200
TDH Maximum (Ft) 26
TDH Maximum (PSI) 11
Horsepower (IE .5, 1, 1.5, 20) 0.1700
Watts 380.000000
Outlet Connection Type MNPT
Outlet (In.) 1
Wetted Materials Aluminum, PPO-Noryl
Elastomers / O-ring Buna-Nitrile
Voltage (V) 115
Voltage (Range) 110-120
Phase (Ø) Single (1)
Motor Frequency 60
Motor Hermetically Sealed
Self Priming Yes
Max Operating Temperature (F) 104
Viscosity Milk 3.20 cp 40.00 ssu
Shaft 304SS
Mechanical Seal LIP
Mechanical Seal Type Single
Approvals UL
Impeller Material Plastic, semi-open
Cord Length (Ft.) 10
Duty Continuous
Drain Yes
Port Rotation Yes
Country of Manufacture United States
Weight (Lbs) 11.000000
Warranty (YRS.) 2

Supporting Docs

Supporting Docs
(Size: 127.54 KB) Extension: pdf