Stanley Hydraulic Submersible Pump

High-Performance Hydraulic Trash Pump

The Stanley TP03 Trash Pump exemplifies the power of hydraulic tools, just like our dewatering pumps. The lightweight and durable urethane bowl and impeller make the TP03 capable of handling demanding job site conditions. The Stanley TP0300301 model discharges an impressive 450 gallons per minute (1688 LPM) and can pass solids up to 3 inches (76 mm) in diameter.

This pump can handle water containing up to 30% solids by volume, making it ideal for pumping water, sand slurries, gravel, and sludge on job sites.

Click here for alternate gas engine submersible.

Stanley TP03 trash pump features include:

• Hydraulic oil operating range: 7–9 GPM (26–34 LPM), 2000 PSI
• Impeller: Urethane (TP03) and cast iron (TP08)
• Submersible: no priming required
• Dry run capability: can run without damage
• Solids handling: up to 25% by volume
• Bowl material: Urethane (TP03) and steel (TP08)
• Accessories: 52720 Adapter (3" male NPT x 2" male camlock), 73576 Carrying Handle, 73577 Quick Link Connector, HTMA quick disconnect couplers
• Discharge diameter: 3 inches (TP03) and 4 inches (TP08) with male QD camlock
• Wingnuts: for easy bowl removal and cleaning

The urethane bowl is virtually indestructible—tough, lightweight, abrasion-resistant, resilient, and impervious to petrochemical solvents. The TP03 can pump almost anything without damaging the bowl. Its efficient design positions the urethane impeller above material flow, reducing blockages and jamming.

For easy maintenance, simply remove the wingnuts and top plate, clean the bowl, and replace the cover and nuts—getting you back to work in less than five minutes. The TP03’s ability to run dry without damaging the motor or impeller reduces downtime. It quickly and efficiently empties sumps, vaults, septic systems, trenches, and more.

With a custom bottom plate including a hose connection, these pumps can “slurp” or draw liquid from deeper locations using a suction tail pipe, ideal for underwater excavating. Consult your PumpBiz Application Engineer for guidance.

Specifications:

• Pressure: 1500–2000 PSI / 105–140 bar
• Flow Range: 7–9 GPM / 26–34 LPM
• Maximum Flow: 9 GPM / 34 LPM
• Porting: 1/2 in. NPTF
• Connect Size & Type: 1/2 in. Male Pipe
• Discharge Diameter: 3 in. / 76.2 mm Camlock

Important Note: Hydraulic motors must return into an open/non-pressurized reservoir. Back pressure on the discharge or return side can damage the shaft seal. Skid steer operators should be aware of this.