Tsurumi

Power cord for pump model HS2.4S LB480 115v made by Tsurumi. Tsurumi Submersible Pump power cord for pumps like LB-480. 20FT long, shorter than originally with pumps. Includes plug and rubber strain relief with SS metal cover.

Discharge Port Flange – 2" MNPT

Replacement 2" male NPT discharge flange for Tsurumi LB-480 submersible pumps. 

• Gasket used: Tsurumi 121-587-17
• Replacement seal oil: 30214

Durable OEM part for a secure, leak-free connection.

• Watertight Cable Entrance with Anti-wicking block.
• Permanently lubricated sealed ball bearings rated B-10 60,000 hours.
• Built in motor protection
• Continuous duty air filled copper...

Impeller for EPT3-100HA Tsurumi 4" Trash Pump.

Replacement pump part for Tsurumi Trash pumps EPT3-100HA/RX/RWA. Solid cast iron non-clog design. Impeller screws off gas engine shaft, standard thread.

When replace the impeller you should also rep...

Tsurumi Submersible Pump power cord with float for pumps HSZ3.75S-61 115v and 230v 32FT long same as originally with pumps. Includes plug and rubber strain relief with SS metal cover.  For the 230v pumps, simply cut off the plug. 14/3. Also fits S...

Shaft Seal – For EPT3 Trash Pump

The Tsurumi 821-008 Shaft Seal is a genuine replacement part designed for use with Tsurumi EPT3 Trash Pumps. This mechanical shaft seal fits both 3" and 4" Tsurumi trash pump models, including EPT3-80HA, EPT3-80...

Tsurumi Submersible Pump Shaft Seal 025-291-10 for pumps LB480 ; HS2.4 series

A worn impeller will greatly reduce the pumps performance output, most notable when pumping up and out ie basement.

Shaft seals can not be returned.