My Cart

Hydrasub Submersible Pump 3"

35588 3"
Model Number
35588
$2,550.00
MP_hydrosub 3" submersible pump hydraulic powered
MP Pumps Submersible hydraulic driven pump 3". 35588. A compact, lightweight, hydraulically driven submersible pump with high flow capabilities. This self-priming pump is made with a high strength aluminum alloy that is anodized for corrosion resistance. This pump features a stainless steel impeller, ball bearing, and a gerotor type hydraulic motor. HYDROSUB 20 / 25 / 30 may be used to pump out underground vaults and pits, golf course sand traps bunkers. High suction lift applications such as sewer bypass jobs. Dewatering of mines, quarries and gravel pits. Benefit: No suction line limitations. Unattended operation. Submerged pump head. Variable speed. No electrical requirements. Trash type impeller also good for food waste streams.

Can run dry. No priming required. Pumps down to 3/4"

DO NOT use in explosive atmospheres or pump volatile liquids.

More Information
Model Number 35588
part number MP35588
Series Hydrasub Submersible Trash Pump
Max Flow (GPM.) 400
Max Flow GPH 24000
TDH Maximum (Ft) 96
TDH Maximum (PSI) 42
Outlet (In.) 3
Wetted Materials 304SS, Aluminum
Elastomers / O-ring Viton
Motor Hydraulic Motor
Speed (RPM.) variable
Max Particle Size (In) .5
Viscosity Vegetable Oil 34.60 cp 200.00 ssu
Mechanical Seal LIP
Mechanical Seal Type Single
Impeller Number (In.) 30851
Other includes quick disconnect. HYDRAULIC OIL SYSTEM REQUIREMENTS: The hydraulic power supply must be capable of delivering a controlled flow rate of 5-9gpm for Model 20 and 8-14gpm for Model 25. The operating oil pressure will vary upon the flow rate load of the pump from 700 to 2100 psi. A maximum relief valve setting of 2400psi is recommended. A hydraulic supply system where the flow rate is controlled is referred to as an ?open center system.? This is the most accurate system to assure that the flow rate does not exceed the maximum limit. A ?closed center system? will have a variable oil flow rate based upon the hydraulic pressure that is a set value. If a closed center system is used, the maximum pressure developed must not exceed 1700 psi, and the pump must always have a supply of water to pump to protect it from running into an over speed condition unless the oil flow rate is limited to less than the maximum. The maximum return pressure or backpressure is 100psi. Higher pressures will result in reduced seal life. Do not install down stream loads or valves. Always allow the return to go directly back to the tank. Supplemental oil cooling may be required to keep the oil temperature below 1750F. Suitable filtration is required (25 micron recommendation) to clean the oil of contaminants that may accelerate wear. 0.58cu in. gerotor type hydraulic motor
Impeller Material SS, Non-clog
Duty Continuous
Drain No
Port Rotation No
Country of Manufacture United States
Weight (Lbs) 15.000000
Warranty (YRS.) 1

Supporting Docs

Supporting Docs
pdf
(Size: 130.65 KB) Extension: pdf