Drum pump - AL-39 and air motor- SP-A2

Hazardous Location Drum Pump Motor and Pump Combination. Drum Pump Motor: High volume compressed air motor, operating pressure = 92 psi ( 6.32 bar) @ 28 cfm, includes muffler, inlet = 3/8" 9.5 mm). Drum Pump, High Volume. Aluminum construction, TFE guide sleeve, 39" ( 1000 mm) immersion. In applications where electricity is unavailable or dangerous, use these pumps with a non-sparking air-powered motor. They have an NPT female air connection. Total weight 11 lbs. 

• 1.5" pump tube diameter OD (old SS-39 had a 1.65" OD)

Same as 8252K12 and 2824K39.

These pumps are rated for Zone 0 hazardous locations. Acetone, Diesel Fuel, Ethanol, Gasoline, Hydraulic Oil, Isopropyl Alcohol, Kerosene, Lacquer Thinner, Methanol, Methyl Ethyl Ketone, Mineral Spirits, Motor Oil, Nitric Acid (20%), Paint, Phosphoric Acid, Xylene. With a length of 1" hose and the result flow restriction the practical flow rate will reduce to approximately 35gpm. Maximum flow is achieved by using a 1-1/4" hose or larger.

Air motor air pressure can be varied between 44-87 psi.

Bonding / grounding wire included. 

WARNING: Pumping of flammables or combustible liquids can generate a static electric discharge, causing fire or explosion resulting in injury or death. Read and understand operating instructions before starting this unit. Follow all federal, state and local safety codes including NFPA 30 - NFPA77. Prior to connecting to air supply, install bond and ground wires and check continuity of each wire. A meter reading of one ohm or less is required for safe liquid transfer. Use only metallic drum, receiving vessel and metallic pump (SP-SS) when pumping flammables.