My Cart

Commercial Duty 12vDC water pump

Model Number
Jabsco 18670-0123 Commercial Duty 12vDC water pump

Jabsco 18670-0123

Commercial Duty Water Puppy has 25% more flow than the standard model and a heavy duty PMDC motor. For general transfer pumping where self-priming, 8 gpm flow and debris tolerance are required. Oil-resistant nitrile impeller is standard. Do not pump gasoline or other flammable liquids. DO NOT RUN DRY.

This is the pump you've been searching for! This is like the pump used in most factory wakeboard ski boat ballast systems. This pump is a 12volt, reversible, high volume, ballast system necessity. Stop tossing pumps over the side of the boat, and enjoy a clean custom ballast system. 15 amp fuse. Ports are dual size, threaded internally and a external 1" hose barb. Includes a garden hose adapters. Water Puppy Shower Drain Pump. See Ballast Puppy for ski boats.

Complies with USCG 183.410 marine ignition protection.

Our most common primer pump. Pump has a dry prime lift of 6ft. and a lift to 20ft. when primed. Permanent magnet type, fully enclosed stainless steel shaft, ball type shaft bearing. 3" high, 6-7/8" long, 4-3/4" wide

More Information
Model Number 18670-0123
Series 18670 Commercial Duty DC
Max Flow (GPM.) 8
Max Flow GPH 480
TDH Maximum (Ft) 20
TDH Maximum (PSI) 9
Inlet Connection Type FNPT
inlet size Less than 1"
Inlet (In.) 0.5
Outlet Connection Type FNPT
Outlet (In.) 0.5
Wetted Materials Bronze
Elastomers / O-ring Buna-Nitrile
Voltage (V) 12DC
Voltage (Range) 12/24/36 VDC
Motor TENV
Speed (RPM.) 2850
Self Priming Yes
Suction Lift (FT.) 6
Max Operating Temperature (F) 180
Viscosity Cream 16.50 cp 100.00 ssu
Length (In.) 6.880000
Mechanical Seal LIP SEAL
Mechanical Seal Type Single
Other permanent magnet motor with ball bearings. Black wire is NEG. Jabsco reversing switch 18753-0652 may be used for reversing. Preferred rotation is clockwise looking at the pump. Do not run against a closed valve / outlet. Do not run dry.

Fuse size 20. Wire size min. is #14 for 0-10 ft and #12 for 10-20 ft length. Length is TOTAL of neg. and pos. wires. Without correct wire size the voltage drop will cause a increase in motor temperature and its thermal overload will kick the motor off. If the impeller is allowed to dry out after use, it may stick and prevent the motor from turning. Lubricate the impeller in this case. Caution: Do not pump flammable liquids like gasoline.

Drain Yes
Port Rotation Yes
Weight (Lbs) 8.000000
Warranty (YRS.) 1