Search results for: 'flow n stow pump kit'
-
Tsurumi
Residue Kit Low Level
HS-RK
$55.00Low Level Residue Kit for Tsurumi Submersible Sand Trash Pumps HS series. The residue kit allows pumping of residual water down to 0.4 inches, close to floor level. Rubber coated steel. HSRK
This is a customer installed option.
-
Finish Thompson Pumps (FTI)
Stainless Flow Nozzle
107464
$383.99Stainless Steel Nozzle for flow control and automatic shut off. Much like those used at a service station. Heavy duty with FKM elastomers. -
Pedrollo Pumps
BEST CONTROL Electric Flow Controller
PCBC 16F16S-22
$341.00Electric Flow Controller or water well / booster pump flow switch. 22PSI
When the pressure available is insufficient it is necessary to install a boosting system. TOTAL CONTROL electronic pump controller starts and stops the water pump according ...
BEST CONTROL is an electronic pump switch 22PSI Learn More -
Serfilco
Dri Stop switch DSWF
99-1152R
$493.27Dri-stop control switch monitors the low flow of water to a double mechanical sealed or water flushed vertical pump with bearings. This unique flow switch constantly controls the pumps via the control circuit of their magnetic motor starter conta... -
Koshin Pumps
Wheel Kit for Pumps
WK-12 BAE
$237.60Wheel kit for pumps with roll cage like KTH. The WK-12 BAE is for KTH-80s and KTH-100S by Koshin. Epoxy coated steel handles with grips, zinc shaft and fasteners.for KTH-80s and KTH-100S Learn More -
Koshin Pumps
Wheel Kit for Pumps
WK-12 BAF
$165.00Wheel kit for Koshin pumps with roll cage. WK-12 BAF is for all Koshin pumps except the KTZ-50, 80 and 100, KTH-80s and KTH-100S by Koshin. Epoxy coated steel handles with grips, zinc shaft and fasteners. -
Scott Aerator
Splice kit submersible pump cable
20120
$39.55Splice kit submersible pump cable. Includes multiple heat shrink tubes, metal butt wire connectors and instructions. Use with submersible pump cable 28113Splice Kit Learn More -
Munro Pumps
Flow Sleeve & SS Stand
SA400FS&S
$356.00According to the Picture:
- Submersible Pump & Motor: Installed in cistern at 15ï½° angle with flow sleeve to meet manufacturer's requirements.
- Check Valve: Holds system pressure from flowing back into cistern or main city line.
- Discharge Hose: NS...
-
Munro Pumps
Flow Sleeve & SS Stand
SA400FS&S125
$356.00According to the Picture:
- Submersible Pump & Motor: Installed in cistern at 15ï½° angle with flow sleeve to meet manufacturer's requirements.
- Check Valve: Holds system pressure from flowing back into cistern or main city line.
- Discharge Hose: NS...
-
Finish Thompson Pumps (FTI)
Static protection kit
107429
$436.72FTI static protection WIREs and HOSE kit, wire assembly for the Finish Thompson series TMS drum barrel mixers. Must be used when pumping flammable liquids. Drums and pumps must be electrically grounded and bonded to prevent static electricity b...Grd wires and Hose Learn More