Search results for: 'march wet end kit for te 75k md 0156 0031 0100'
-
General Pump
Jetter Valve Kit
100316
$132.00Jetter valve kit for some General Pump brand pumps like the TX1510. Replaces middle cap and then with a simple twist on / off it creates the pulsation needed for jetting. -
March Pumps
Priming chamber
0750-0227-0100
$140.00March Priming Chamber to upgrade the pumps to being self-priming. Molded PolyPro priming reservoir.
Priming Reservoir for March 320, 5, 5.5 and 6 series magnetic pumps. Molded tank has 1" MNPT inlet and outlet connections. Top fill cap. Holds abo... -
Generic Pump
2"x50' Mill Discharge Hose
MDH250
$171.00Heavy duty Mill grade water discharge hose used on job sites with lots of moving of the hose or a high pressure pump is being used. Rated 250 PSI. Includes male and female threaded aluminum end fittings. Will lay flat for easy coiling.Constructi...
-
PumpBiz
Float switch
PF15AMDWOP
$95.00120v. Mechanical Wide-Angle, NO PLUG DIRECT WIRING - Units used for direct wiring (without plug) may be used in 125 VAC or 250 VAC applications within specified amp ratings. CABLE: Flexible 14 gauge, 2 conductor (UL, CSA) SJOO/W, water-resis...115v Pump Down. 3/4HP at 120 VAC and 2 HP at 230 VAC Learn More -
Finish Thompson Pumps (FTI)
Static protection kit
107429
$436.72FTI static protection WIREs and HOSE kit, wire assembly for the Finish Thompson series TMS drum barrel mixers. Must be used when pumping flammable liquids. Drums and pumps must be electrically grounded and bonded to prevent static electricity b...Grd wires and Hose Learn More -
Koshin Pumps
Wheel Kit for Pumps
WK-12 BAF
$165.00Wheel kit for Koshin pumps with roll cage. WK-12 BAF is for all Koshin pumps except the KTZ-50, 80 and 100, KTH-80s and KTH-100S by Koshin. Epoxy coated steel handles with grips, zinc shaft and fasteners. -
Koshin Pumps
Wheel Kit for Pumps
WK-12 BAE
$237.60Wheel kit for pumps with roll cage like KTH. The WK-12 BAE is for KTH-80s and KTH-100S by Koshin. Epoxy coated steel handles with grips, zinc shaft and fasteners.for KTH-80s and KTH-100S Learn More -
Finish Thompson Pumps (FTI)
Static protection kit wires
A100961
$47.70FTI static protection WIRE kit, wire assembly for the Finish Thompson series TMS drum barrel mixers. Must be used when pumping flammable liquids. Drums and pumps must be electrically grounded and bonded to prevent static electricity build up. K...Grd wires Learn More -
Tsurumi
Residue Kit Low Level
HS-RK
$55.00Low Level Residue Kit for Tsurumi Submersible Sand Trash Pumps HS series. The residue kit allows pumping of residual water down to 0.4 inches, close to floor level. Rubber coated steel. HSRK
This is a customer installed option.
-
Tsurumi
Sand Kit Agitator for NK2
K15-SK
$217.00Sand kit with agitator allows continuous duty when pumping abrasive materials. Agitator kit to suspend solids and prevent clogging. For Tsurumi contractor dewatering pumps NK2 series only.