Horizontal Pumps
Designed and meant to be used as a horizontally mounted assembly.
This includes feet on the pump, motor or both for securing the pump
and motor to its floor or structure. The most common type of
Horizontal pump is the End Suction, where the fluid enters the
front end of the casing and exits perpendicularly. The source of
liquid is either above the pump, in which case it is a positive
head and no special priming is needed. If the liquid source is
below the pump then either a priming chamber is needed or use of
some sort of suction side valve, i.e. foot valve, to maintain prime
in an open pumping system. If the inlet and outlet go into the same
tank, i.e. re-circulating or filtering, and the lines are kept
below the surface level, then after initial priming the system will
maintain its prime.The two big considerations that must be given to
horizontal pumps is priming method and NPSHa.Typical Centrifugal
Horizontal pumps include mechanically sealed, magnetic coupled
seal-less, self-priming, multistage, jet, back pullout, portable,
API and ANSI to name a few.
-
MP Pumps
MP Centrifugal pump
22852
$1,180.00MP Centrifugal pump. Series 30 End Suction Centrifugal Pump uses a close-coupled Cast Iron Electric Motor-0.5 HP, 3-phase, 230/460 V. The pump has 1" NPT suction and 0.75" NPT horizontal or vertical discharge. MP Centrifugal pump made in MI. -
MP Pumps
Series 30 w/ motor
24189
$960.00Series 30 End Suction Centrifugal Pump uses a close-coupled Cast Iron Electric Motor-0.5 HP, 3-phase, 230/460 V. The pump has 1" NPT suction and 0.75" NPT horizontal or vertical discharge. -
MP Pumps
Series 30 w/ motor
26542
$1,430.00Series 30 End Suction Centrifugal Pump uses a close-coupled Cast Iron Electric Motor-0.75 HP, 3-phase, 230/460 V. The pump has 1" NPT suction and 0.75" NPT horizontal or vertical discharge. -
MP Pumps
Series 30 w/ motor
22771
$1,200.00Series 30 End Suction Centrifugal Pump uses a close-coupled Cast Iron Electric Motor-0.75 HP, 3-phase, 230/460 V. The pump has 1" NPT suction and 0.75" NPT horizontal or vertical discharge. -
MP Pumps
Series 30 w/ motor
25434
$690.80Series 30 End Suction Centrifugal Pump uses a close-coupled Cast Iron Electric Motor-1 HP, 3-phase, 230/460 V. The pump has 1" NPT suction and 0.75" NPT horizontal or vertical discharge. -
Hypro Pumps
316SS pump .3HP
COMSV11
$1,237.05Close-Coupled Centrifugal Pump, 316 SS investment cast end-suction pump. Producing High flow rates, under low-head conditions. Designed for continous low-pressure circulatioon and transfer of non-flammable liquids, utility, boiler feed, general...1/3HP 115/230v Learn More