Horizontal Pumps
Designed and meant to be used as a horizontally mounted assembly.
This includes feet on the pump, motor or both for securing the pump
and motor to its floor or structure. The most common type of
Horizontal pump is the End Suction, where the fluid enters the
front end of the casing and exits perpendicularly. The source of
liquid is either above the pump, in which case it is a positive
head and no special priming is needed. If the liquid source is
below the pump then either a priming chamber is needed or use of
some sort of suction side valve, i.e. foot valve, to maintain prime
in an open pumping system. If the inlet and outlet go into the same
tank, i.e. re-circulating or filtering, and the lines are kept
below the surface level, then after initial priming the system will
maintain its prime.The two big considerations that must be given to
horizontal pumps is priming method and NPSHa.Typical Centrifugal
Horizontal pumps include mechanically sealed, magnetic coupled
seal-less, self-priming, multistage, jet, back pullout, portable,
API and ANSI to name a few.
-
Flotec Pumps
CI Shallow well Pump 1/2
FP4112
$403.56Cast Iron shallow well jet pump water pump. 1/2 HP * Superior performance at depths to water of 25' or less. * Rugged, heavy-duty cast iron pump housing. 1-1/4" NPT suction and 1" NPT discharge pipe sizes.Ready-to-install dual voltage (115v/23... -
Sta-Rite
Shallow well Pump 1/2HP
FNC-L
Cast Iron shallow well jet pump water pump. 1/2 HP electric motor.
Also often used as a sprinkler pump with built in automatic on / off using included pressure switch.
* Superior performance at depths to water of 25' or less. * Rugged, heavy-dut...
115/230v 1/2hp Learn More -
Sta-Rite
1/2HP Shallow Jet pump
PNC-10
1/2HP Shallow Jet pump, water well / sprinkler
FRP (Polypro) engineering plastic pump is corrosion and abrasion resistant. Built in jet is corrosion resistant Noryl nozzle and venturi. UL/CSA listed A.O. Smith motor with thermal overload. 1/2HP. ...
1/2HP 115v Learn More