Horizontal Pumps
Designed and meant to be used as a horizontally mounted assembly.
This includes feet on the pump, motor or both for securing the pump
and motor to its floor or structure. The most common type of
Horizontal pump is the End Suction, where the fluid enters the
front end of the casing and exits perpendicularly. The source of
liquid is either above the pump, in which case it is a positive
head and no special priming is needed. If the liquid source is
below the pump then either a priming chamber is needed or use of
some sort of suction side valve, i.e. foot valve, to maintain prime
in an open pumping system. If the inlet and outlet go into the same
tank, i.e. re-circulating or filtering, and the lines are kept
below the surface level, then after initial priming the system will
maintain its prime.The two big considerations that must be given to
horizontal pumps is priming method and NPSHa.Typical Centrifugal
Horizontal pumps include mechanically sealed, magnetic coupled
seal-less, self-priming, multistage, jet, back pullout, portable,
API and ANSI to name a few.
-
Webtrol
Corrosion Resistant Pump
PC100R-3PH
$2,329.44Corrosion resistant Centrifugal Pump.- Glass Reinforced Noryl
- Close coupled
- Ability to rotate the discharge in 90 degree increments.
- 316 stainless steel impeller insert & wear ring
1HP 208-230/460V ODP Learn More -
Pacer Pumps
GNOK1.5/2CLK1.0C
60-61C4K1.0C
$1,183.60The self-priming series G pump is made in Noryl, providing a maximum corrosion resistance in various water applications. Fountains, waterfalls, pools irrigation. The pump comes standard with 304 stainless external hardware. The pump is protecte...