Horizontal Pumps
Designed and meant to be used as a horizontally mounted assembly.
This includes feet on the pump, motor or both for securing the pump
and motor to its floor or structure. The most common type of
Horizontal pump is the End Suction, where the fluid enters the
front end of the casing and exits perpendicularly. The source of
liquid is either above the pump, in which case it is a positive
head and no special priming is needed. If the liquid source is
below the pump then either a priming chamber is needed or use of
some sort of suction side valve, i.e. foot valve, to maintain prime
in an open pumping system. If the inlet and outlet go into the same
tank, i.e. re-circulating or filtering, and the lines are kept
below the surface level, then after initial priming the system will
maintain its prime.The two big considerations that must be given to
horizontal pumps is priming method and NPSHa.Typical Centrifugal
Horizontal pumps include mechanically sealed, magnetic coupled
seal-less, self-priming, multistage, jet, back pullout, portable,
API and ANSI to name a few.
-
Myers Pumps
2 Stage 2C200 Pump & Motor
2C200
$3,830.00Myers 2-Stage Centrifugal Pumps deliver high performance with a rugged design for years of trouble-free service. The 2-stage pumps are available as a completely assembled pump and motor or pump end. The fully assembled pump end quickly mounts t...230v 2HP Learn More -
AMT Pumps
Cast Iron Centrifugal Pump
369D-95
$820.00Cast Iron Centrifugal Pump Designed for continuous-duty low pressure OEM, Industrial Commercial and General Service applications including circulation, water process, liquid transfer and cooling. Single phase TEFC motor. Circulation Pumps for Wate...
115/230v 2HP TEFC Learn More