Horizontal Pumps
Designed and meant to be used as a horizontally mounted assembly.
This includes feet on the pump, motor or both for securing the pump
and motor to its floor or structure. The most common type of
Horizontal pump is the End Suction, where the fluid enters the
front end of the casing and exits perpendicularly. The source of
liquid is either above the pump, in which case it is a positive
head and no special priming is needed. If the liquid source is
below the pump then either a priming chamber is needed or use of
some sort of suction side valve, i.e. foot valve, to maintain prime
in an open pumping system. If the inlet and outlet go into the same
tank, i.e. re-circulating or filtering, and the lines are kept
below the surface level, then after initial priming the system will
maintain its prime.The two big considerations that must be given to
horizontal pumps is priming method and NPSHa.Typical Centrifugal
Horizontal pumps include mechanically sealed, magnetic coupled
seal-less, self-priming, multistage, jet, back pullout, portable,
API and ANSI to name a few.
-
AMT Pumps
Two Stage Sprinkler Booster 3HP
4782-95
$1,599.003HP Sprinkler Booster pumps feature Investment Cast 316 SS closed impellers for high efficiency and resistance against erosion caused by abrasive particles. All models self-prime to 20 feet. Single stage models feature a built-in check valve to in...
3HP 230v/1 ODP 3480 GPH Learn More -
American Stainless
SS pump & motor
C15425B3D2
$894.12Models SSP & SSPC pumps have a one-piece shell, capable of supporting the pump and motor weight in a vertically mounted position. The internal design also prevents any air from being trapped in the pump case when mounted vertically. These pumps...3HP 208-230V ODP Learn More