Search results for: 'horizontal centrifugal pump mtr 13621'
-
Generic Pump
Lawn controller 3hP
MPLC2203
$655.003 HP pump controller, single phase with 220 VAC contactor coil. 115 VAC / 230 VAC Includes voltage & HP specific thermal protection for the motor and a terminal block. Includes pressure switch for mounting to pump discharge.Box is 8x8x4"220V coi...
-
Generic Pump
Check valve
26-6
$9.00Basic check valve 1-1/4" MNPT pump thread connection x 1-1/4" Hose barb. Can also be fitted to 1-1/2" pipe with a rubber hose adapter (not supplied). Has dual size threads for 1-1/4" and 1-1/2" along with dual size hose barb. So this economy chec... -
Rhombus
15PMUWP
10027201
$56.86SJE PUMPMASTERï½® Pump Switch. Mechanically-activated, wide-angle switch designed for direct control of pumps up to 1/2 HP at 120 VAC. For PUMP UP float switch applications as specified. Often used to control liquid level filling a water tank...Pump UP NC, Piggyback plug Learn More -
General Pump
Jetter Valve Kit
100316
$132.00Jetter valve kit for some General Pump brand pumps like the TX1510. Replaces middle cap and then with a simple twist on / off it creates the pulsation needed for jetting. -
PumpBiz
Briggs Engine CP550
1639-047-00
$450.00Briggs Stratton Gas Engine, CP550 Commercial Grade with 3/4" keyed horizontal shaft for mounting certain water pumps. Used with FlexPump P212 pumps. Features • Briggs OHV Commercial-grade engine, 206cc • Cast Iron cylinder sleeve, Horizonta...5HP Briggs Gas Engine Learn More -
PumpBiz
PUD-L-SCOOP Kit
FP000349A
$34.00PUD-L-SCOOP Kit FPOOO349A is for use with Cyclone pump or simular utility pumps. Kit includes 6 FT. garden hose and puddle scoop also know as the Puddle Gulper. Connect to pump and use to remove water from aquariums, pool covers, basement fl... -
Generic Pump
2" Hose Barb 90
58-1611-40
$6.252" MNPT x 2" hose barb 90 degree elbow. Made from strong glass filled polypropylene. Straight is 58-1616-40. Do not use immediately at the suction side of a pump. Best to have 10-20" straight pipe run before the inlet of a pump due to the turbulen...2" MNPT x 2" hose barb 90 degree elbow. Made from strong glass filled polypropylene. Straight is 58-1616-40 Learn More -
AMT Pumps
Installed FKM seal and oring
285X-301-V0
$226.00Installed FKM seal and oring in AMT pump.
Carbon Ceramic / FKM Seal and O-ring installed. Installed in AMT pump 285_-95. This is a factory installed option, not a replacement part.
Parts for all AMT pumps are available at PumpBiz.com
To look ...
Option Learn More -
Munro Pumps
Start Box 220 coil volt
MPSR220
$120.00The Pump Start Relay (PSR) Provides "pilot duty" operation for all types of electricity driven pump equipment. Full compatibility with all 110 volt or 220 volt, single phase pumps, 3/4 HP through 2HP, and all 24V controllers.
- HP: 3/4 through...
Irrigation pump controller 230v Learn More -
PumpBiz
Float Switch
2900-B8-S4-P1-15
$76.00Float switch
Pump Duty Mechanical foam filled(NON- mercury) wide angle float switch for automatic level control of sump pumps and other pump types. Pump Down operation. Rated 13 amp 1/2hp / 115 VAC SPST. 170 F max. Use for pump down, normally ope...
115v 15FT Pump Down NO Learn More