Bronze Centrifugal Pump Pedestal
-
Model Number:
70P
-
Product Name:Bronze Centrifugal Pump Pedestal
-
Manufacturer:
-
Series (3 Models):
Model Number
70P
$814.00
Oberdorfer 70P
Bronze Centrifugal Pedestal mounted for long coupling to customer drive. The liquid flow is proportional to the pump speed--the higher the speed the greater the flow. Horsepower requiredvaries directly as flow and pressure. P70
Model 70P used in concrete cutting flat saws like Husqvarna, Diamond Boart, Norton and STW. Coolant to blades for floors, driveways, highways, streets, runways, concrete and asphalt target sawing cutting.The pedestal centrifugal pumps can be direct driven by electric motors at either 3450 R.P.M. or 1725 R.P.M. Performance for both speeds are shown in the curves above. The 70P pedestal centrifugal pumps can be pulley driven at any desired intermediate speed.
- All Bronze
- Marine, Flat saws
- Carbon Face Mechanical Pump Seal
- Cast Iron bearing pedestal with ball bearings
- Will Handle Contaminated Liquids
- Extremely Quiet
- A Standard in the Marine Air Conditioning Industry
- Counter-Clockwise Rotation
Heavy liquids can be pumped; however, they demand morehorsepower in direct ratio to the weight of water. Because centrifugal pumps are more efficient at higher shaftspeeds, pumping of viscous or thick liquids is difficult.
| Model Number | 70P |
|---|---|
| part number | 70P |
| Series | Bronze Centrifugal |
| Max Flow (GPM.) | 90 |
| Max Flow GPH | 5400 |
| TDH Maximum (Ft) | 90 |
| TDH Maximum (PSI) | 39 |
| Watts | 0.000000 |
| Inlet Connection Type | FNPT |
| inlet size | 1 ¼" |
| Inlet (In.) | 1.25 |
| Outlet Connection Type | FNPT |
| Outlet (In.) | 1 |
| Wetted Materials | 304SS, Bronze |
| Elastomers / O-ring | Buna-Nitrile |
| Speed (RPM.) | variable |
| Self Priming | Yes |
| Max Operating Temperature (F) | 212 |
| Viscosity | SAE 30 oil 352.00 cp 2000.00 ssu |
| Shaft | 304SS |
| Mechanical Seal | No |
| Mechanical Seal Face | Carbon-ceramic |
| Mechanical Seal Type | Single |
| Other | This centrifugal pump is not self priming. Normally these pumps must be installed below the liquid level so that the liquid flows to the pump by gravity. However, if a foot valve is used at the beginning of the suction line and all air is bled from the suction line and pump by careful manual priming, these pumps will lift liquid on the suction side up to 15 ft. Such a system is only as positive as the ability of the foot valve to seal and keep the suction line and pump full of liquid. If the foot valve should leak, the pump will not prime. |
| Drain | No |
| Port Rotation | Yes |
| Country of Manufacture | United States |
| Weight (Lbs) | 12.000000 |
| Warranty (YRS.) | 1 |
Supporting Docs
Supporting Docs
You May Be Interested In
