My Cart

Bronze Centrifugal Pump Pedestal

Model Number
60PS-10
$586.00
Oberdorfer 60PS-10 Bronze Centrifugal Pump Pedestal

Oberdorfer 60PS-10

Bronze Centrifugal Pedestal mounted for long coupling to customer drive. The liquid flow is proportional to the pump speed--the higher the speed the greater the flow. Horsepower required varies directly as flow and pressure. Maximum horsepower is required with a wide open discharge line. This is the point of maximum flow. With a throttled discharge, the flow decreases at a greater rate than the pressure increases thereby requiring less horsepower at the higher pressures. This is known as an “unloading” feature of the pump. The pedestal centrifugal pumps can be direct driven by electric motors at either 3450 R.P.M. or 1725 R.P.M. Performance for both speeds are shown in the curves above. The 60P pedestal centrifugal pumps can be pulley driven at any desired intermediate speed.
  • All Bronze
  • Marine, Flat saws
  • Carbon Face Mechanical Pump Seal
  • Cast Iron bearing pedestal with ball bearings
  • Designed for Pulley Drive
  • No bearing lubrication required
  • For Close Coupled Style, see Model 600
  • Will Handle Contaminated Liquids
  • Extremely Quiet
  • A Standard in the Marine Air Conditioning Industry
  • Counter-Clockwise Rotation facing pump end

Heavy liquids can be pumped; however, they demand morehorsepower in direct ratio to the weight of water. For example, carbontetrachloride has a specific gravity of 1.6 which means it is 1.6times heavier than water and the horsepower required is 1.6 timeswater horsepower. Because centrifugal pumps are more efficient at higher shaftspeeds, pumping of viscous or thick liquids is difficult.The 60P centrifugal pump has an external ball bearingisolated from the liquid being pumped. The ball bearing is greased and sealed for life, requiring no maintenance.

More Information
Model Number 60PS-10
part number 60PS-10
Series Bronze Centrifugal
Max Flow (GPM.) 22
Max Flow GPH 1320
TDH Maximum (Ft) 52
TDH Maximum (PSI) 22
TDH BEP (FT.) 32.000000
Inlet Connection Type FNPT
inlet size Less than 1"
Inlet (In.) 0.75
Outlet Connection Type FNPT
Outlet (In.) 0.5
Wetted Materials 304SS, Bronze
Elastomers / O-ring FKM
Speed (RPM.) variable
Self Priming Yes
Max Operating Temperature (F) 212
Viscosity SAE 30 oil 352.00 cp 2000.00 ssu
Shaft 304SS
Length (In.) 6.000000
Mechanical Seal No
Mechanical Seal Face Carbon-ceramic
Mechanical Seal Type Single
Motor Bearings Ball
Other This centrifugal pump is not self priming. Normally these pumps must be installed below the liquid level so that the liquid flows to the pump by gravity. However, if a foot valve is used at the beginning of the suction line and all air is bled from the suction line and pump by careful manual priming, these pumps will lift liquid on the suction side up to 15 ft. Such a system is only as positive as the ability of the foot valve to seal and keep the suction line and pump full of liquid. If the foot valve should leak, the pump will not prime.
Rotation CCW facing front of pump
Impeller Material Bronze, open
Duty Continuous
Drain No
Port Rotation Yes
Country of Manufacture United States
Weight (Lbs) 12.000000
Warranty (YRS.) 1
>