Product was successfully added to your shopping cart.
Jet Pump Pool Pump motors
Cast iron NEMA 56J face mounting face or aluminum as noted.
Mechanical bearing lock - shaft end. Fully enclosed endbell at
switch-end. Protected "double contact" starting switch with dual
contact switch circuit providing maximum starting dependability.
Reliable, field proven, corrosion resistant rotating switch. Stator
impregnated with extra heavy varnish system. High temperature
copper magnet wire providing extended motor life. "Low voltage" run
capabilities. "Super Hush" flow-through ventilation system (exhaust
shaft-end). Gaskets supplied under conduit cover and capacitor case
giving added environmental protection. 1/2" NPT pipe tap supplied
in "built-in" conduit box. Grounding provisions inside terminal
panel plus external provision. High overload capacities provided by
service factor.Shaft MaterialKeyed shafts are made of carbon steel.
Threaded shafts are 303 stainless steel. Bearings304 Double-sealed
ball bearing, shaft-end; 203 Double shielded ball bearing,
switch-end.Terminal¼" quick connects (keyd shaft
motors are reversible).U.L. and C.S.A. Recognized. Important: Total
horsepower (HP x service factor) of replacement motor must equal or
exceed motor being replaced. 1 HP X 1.25 SF = 1.25 THP.
Explosion Proof Hazardous Duty motor. Shaft MaterialThreaded
shafts are made of stainless steel. This motor is a TENV EXP
enclosure.Bearings304 Double-sealed ball bearing, shaft-end;
203 Double-shielded ball bearing, switch end.