Product was successfully added to your shopping cart.
30520 Epoxy Pumps
Use where single or variable speed orperation and Plastic Epoxy
material is desirable. Self-priming, 22 gpm flow, debris tolerant.
Nitrile impeller is ideal for oil based products. Use Neoprene for
water and general purpose pumping. Use Viton for hydrocarbons and
most solvents. Optional EPDM standard and high pressure impeller
kits 8981-0002 and 8840-0002 for hygienic applications and some
keystone solvents. Use Tungsten Carbide seal when pumping highly
corrisive or abrasive fluids. Do not pump gasoline or other
flamable liquids. Motor is not explosion proof. DO NOT RUN DRY.
For pumphead only models (30520-3xxx) select NEMA 145TC Frame
C-Face motor rated a 1 1/2 hp at 1750 RPM with appropriate service
factor. Motor must handle high axial loads. Front ball bearing
locked against axial movement is recommended. Motor must deliver
4.8 ft-lbs and 11.2 ft-lbs torque minimum in forward and reverse
directions respectively. Use only capacitor start motors.
For pedestal mount models (30510-1xxx) operating at 1750 RPM,
select 1 1/2 hp or 3 hp motor for standard or high pressure
impellers, respectively, with and appropriate service factor. For
high prssure impellers, the motor must supply 7.9 ft-lbs or 16.3
ft-lbs of torque minimum for foward and reverse operation
Rated flow is based on Neoprene impeller pumping water. Reduce
rated flow 10% for Nitrile,Viton, and EPDM standard impellers.
Reduce rated flow 15% for Nitrile, Viton, and EPDM high pressure
Use where single or variable speed operation and 316 Stainless
Steel material is desirable. Self-priming, 22 gpm flow, and debris
tolerant. Nitrile impeller is ideal for oil based products. Use
Neoprene for water and general purpose pumping. Use ...